This training is meant for 3D designers. No specific knowledge about the software is necessary when participating in this course, only some basic knowledge about Plant design and engineering, making drawings, pipe layouts and ISO/Spool drawings is recommended.
Prerequisites: Basic knowledge about Plant design and engineering, making drawings, pipe layouts and ISO/Spool
Total training days: 3-(5) days
Maximum participants: 4-8 users
General 3D Modelling
- Introduction to CADMATIC Plant Modeller
- CADMATIC desktop
- User interface (Ribbon, Panes, etc.)
- Views (create and manipulate)
- Inspection view
- Navigation commands
- Object Browser
- Object Types
- Systems and Lines (Pipe, Duct, Cable tray)
- Edit sets
- Object Selection context menu
- Placing equipment and structural components
- Ownership Management (check in, check out, request/relinquish ownership) Route Pipes
- Insert and edit Beams
- Route Ducts
- Route Cable trays
- Insert and edit Plates
- Using Collision tool
- PM Session, COS Database
eBrowser
- Publishing eBrowser model 1
- Using eBrowser
Drawings
- Create Drawings
- Create and Manage views, Visualization and Change control Annotation
- Document revision
- Bill of material (BOM)
- Plotting and Exporting documents
Listings
- Generate Listings
Piping Isometrics and Spools 2
- Manage Isometrics and Spool documents
- Isometric group vs Isometric document
- Create and update ISO and/or Spool documents
1. eBrowser full or light version must be available if training is on-site
2 Piping Isometrics and Spools is only necessary if a customer uses CADMATIC Pipe Isos&Spools creation tool